Sound Projects - SPX-4
Development Sound Projects - SPX-Diamond (SPX-4) (Internship assignment - Study Industrial Product Design) Almere Stad / Netherlands / 2012
The sound reinforcement system shall hold a 1.4” HF driver on a horn with a horizontal dispersion of 85 degrees and a vertical dispersion of 30 degrees and a low-weight neodymium 12-inch driver on a balance-drive horn loading system, powered by a 1200W amplifier. The maximum peak output of the total system shall be 138dB at 1m. The system shall have a 60Hz-20kHz frequency range. The system shall have a 85 degrees horizontal and 30 degrees vertical coverage angle.
The cabinet shall be constructed of cross grain laminated lightweight multiplex, covered by a protective 2 component polyurethane coating. The total system weight including amplifiers and audio control shall be 45kg only. It shall have an IEC XLR-3 audio in and output connector and a powercon in and thru mains connector.
The system shall be a self-powered design holding its own protective audio logic control electronics and amplifiers within the cabinet.
Acoustical specifications:
- Drivers: 1 x 1.4”, 1 x 12" high power,
low weight, neodymium design.
- Freq. response: 60Hz-20kHz
- Max. peak SPL @1m: 138dB c.f. 2 (6 dB)
- Coverage angle: 85H x 30V
Electrical specifications:
- Amplifier(s): CCD™ technology
- Output: 1200W sine (DALC limited)
- Crossover: 1.4 kHz, 4th order
- Filter subsonic: 60Hz, 2nd order
- Input impedance: 20 kOhms balanced,
10 kOhms unbalanced
- Output impedance: hard-wired to input
- Power consumption.
- Mains voltage: 230V (other on request)
- Mains frequency: 50/60 Hz
- Idle: < 50VA
- Full load: 1200 VA. DALC limited Ref. to continuous pink noise signal (6 dB crest factor within the specified range)
- Protection
- D.A.L.C. (Dual AudioLogic Control)
- Protection threshold: +4dBU
- Transient (soft power-up)
- DC-voltage short-circuit
- LED indication: power-on/
signal/protect
Additional descriptive data:
- Cabinet construction: cross grain laminated multiplex
- Finish: Nano-armor™ coating
- Weight: 45kg
- Size WxHxD (mm): 450x1200x600 (trapezoid)
- Rigging points: Integrated SPX flypoints,
recessed pole mount.
- Audio connectors: IEC XLR-3 in/out
- Main connectors: powercon in,
powercon out
- Max. operating temp.: -10 to 40 C ambient
Specifications subject to change without notice
The sound reinforcement system shall hold a 1.4” HF driver on a horn with a horizontal dispersion of 85 degrees and a vertical dispersion of 30 degrees and a low-weight neodymium 12-inch driver on a balance-drive horn loading system, powered by a 1200W amplifier. The maximum peak output of the total system shall be 138dB at 1m. The system shall have a 60Hz-20kHz frequency range. The system shall have a 85 degrees horizontal and 30 degrees vertical coverage angle.The cabinet shall be...
- Year 2012
- Work started in 2011
- Work finished in 2012
- Client Sound Projects
- Status Completed works
- Type Music schools/Music academies / Product design
comment